Simulation study of helicopter ship landing procedures incoporating measured flow data

Thomson, D.G., Coton, F.N. and Galbraith, R.A.M. (2005) Simulation study of helicopter ship landing procedures incoporating measured flow data. Proceedings of the Institution of Mechanical Engineers Part G: Journal of Aerospace Engineering, 219(5), pp. 411-427. (doi: 10.1243/095441005X30351)

Abstract

The aim of this article is to investigate the use of inverse simulation to help identify those regions of a ship's flight deck which provide the safest locations for landing a rotorcraft in various atmospheric conditions. This requires appropriate information on the wind loading conditions around a ship deck and superstructure, and for the current work, these data were obtained from wind tunnel tests of a ship model representative of a typical helicopter carrier/assault ship. A series of wind tunnel tests were carried out on the model in the University of Glasgow's 2.65 × 2.04 m wind tunnel and three-axis measurements of wind speed were made at various locations on the ship deck. Measurements were made at four locations on the flight deck at three different heights. The choice of these locations was made on the basis of preliminary flow visualization tests which highlighted the areas where the most severe wind effects were most likely to occur. In addition, for the case where the wind was from 30 to starboard, measurements were made at three further locations to assess the extent of the wake of the superstructure. The generated wind profiles can then be imposed on the inverse simulation, allowing study of the vehicle and pilot response during a typical landing manoeuvre in these conditions. The power of the inverse simulation for this application is demonstrated by a series of simulations performed using configurational data representing two aircraft types, a Westland Lynx and a transport helicopter flying an approach and landing manoeuvre with the worst atmospheric conditions applied. It is shown from the results that attempting to land in the area aft of the superstructure in a 30° crosswind might lead to problems for the transport configuration due to upgusts in this area. Attempting to perform the landing manoeuvre in an aggressive manner is also shown to lead to diminished control margin in higher winds.

• Item Type: Articles
• Keywords: inverse simulation, wind tunnel testing, deck landing
• Status: Published
• Refereed: Yes
• Glasgow Author(s) Enlighten ID: Coton, Professor Frank
• Authors: Thomson, D.G., Coton, F.N., and Galbraith, R.A.M.
• Subjects: T Technology > TL Motor vehicles. Aeronautics. Astronautics
• College/School: College of Science and Engineering > School of Engineering > Autonomous Systems and Connectivity
• Journal Name: Proceedings of the Institution of Mechanical Engineers Part G: Journal of Aerospace Engineering
• Publisher: Professional Engineering Publishing
• ISSN: 0954-4100
• Copyright Holders: Copyright © 2005 Professional Engineering Publishing
• First Published: First published in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering 219(5):411-427
• Publisher Policy: Reproduced with the permission of the publisher